Integrated Columns - Wine Cabinet - Fisher & Paykel RS6121VL2K1 Installation Manual

SAFETY AND WARNINGS
INSTALLATION
Cavity preparation
The anti-tip bracket and fittings supplied must be fitted to the wall of the finished
z
enclosure to withstand a 225lb/100kg load.
Ensure that the anti-tip bracket is installed correctly to prevent the possibility of the
z
appliance tipping forward when the door is open.
Positioning inside the cabinetry
DO NOT attempt to open the door until the appliance is fully installed.
z
Ensure the door of the appliance is closed when rolling into the cabinetry.
z
Ensure the power cord is not run over or damaged when rolling the product
z
into the cabinetry.
Aligning inside the cabinetry
Ensure the doors are in line with the cabinetry front and the appliance is centred.
z
All four corners of the appliance must be supported firmly onto the floor to eliminate any
z
movement. Installing the appliance on a soft, uneven, or not level floor may cause twisting
and poor door sealing.
Fixing inside the cabinetry
Use low speed, low torque setting when using a powered driver for the screws when fixing
z
or aligning the product.
Make sure to remove the depth alignment brackets before fixing the appliance inside
z
the cabinetry.
Open the appliance door to remove the alignment brackets from both sides of the
z
appliance, and then re-tighten the screws.
Door panel installation
Stainless steel
Protect the finish of the Fisher & Paykel Stainless Steel door panels from any
z
scratch or damage.
Leave the protective film on the panels when hanging and remove the film only when the
z
installation is complete.
Custom
If using Custom door panels, ensure they are prepared as per 'Custom door panel
z
dimensions' section.
Ensure the screw pilot holes do not penetrate the full depth of the panel.
z
Do not place the handle holes in marked areas to avoid clashing with panel
z
attachment brackets.
Minimum panel thickness where screw hole is drilled must be 16mm.
z
Door hinge change
Door hinges are interchangeable for each model. A hinge change kit is available
z
and can be purchased separately if you prefer to change from 'right hand hinge' to
'left hand hinge' or vise versa.
INTEGRATED COLUMNS — WINE CABINET
RS6121VR2K1 RS6121VL2K1
5