Moving The Sensor Housing - Fisher & Paykel RS6121VL2K1 Installation Manual

Tools

Moving the sensor housing

T2 star-head
screwdriver
Flat-head screwdriver
OPTIONAL — CHANGE DOOR HINGES
A
Unclip the reed switch
1
from the housing (A).
D
Move the sensor housing so that the
4
opposite reed switch clip is aligned
with the centre of the cabinet (D).
E
Reinstall the sensor housing using
5
#8x16 screws (2x) into the pre-drilled
holes in the cabinet top panel (E).
B
Unhook the interceptor board harness
2
from sensor housing so harness
is loose (B).
F
Clip the reed switch into the sensor
6
housing in the pocket closest to the
centreline of the cabinet (F).
C
Remove the #8x16 screws (2x) from
3
the sensor housing (C).
G
Press the harness from the
7
interceptor board into the forks on
the sensor housing (G).
43