Adjusting The Anti-Scalp Rollers; Using Attachments And Accessories - Toro 75210 Operator's Manual

Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
29.
Figure 29
1. Anti-scalp roller
2. Spacer
3. Bushing
-
EUTRAL LOCK
Figure
g029955
g029955
4. Flange nut
5. Bolt
Using Attachments and
Accessories
Use only Toro approved attachments and accessories.
If you attach a bucket to the engine guard, use a nylon
strap to secure it.
Important:
The bucket weight impacts the
stability of the machine. If you are carrying more
than the weight listed in the table below in a
bucket attached to the engine guard, you must
equip your machine with the Bucket-Support Kit.
Contact your authorized Toro service dealer.
Model
48-inch deck
54-inch deck
60-inch deck
26
Maximum weight per bucket
without the Bucket-Support
Kit
1.1 kg (2.5 lb)
1.1 kg (2.5 lb)
4.5 kg (10 lb)