Using The Smart Speed Tm Control System - Toro 75210 Operator's Manual

CAUTION
The machine can spin very rapidly, which
may cause you to lose control of machine,
resulting in personal injury or damage to
machine.
• Use caution when making turns.
• Slow the machine down before making
sharp turns.
Driving Forward
Note:
The engine stops when you move the
traction-control with the parking brake engaged.
To stop, pull the motion-control levers to the N
position.
1. Disengage the parking brake; refer to
Disengaging the Parking Brake (page
2. Move the levers to the center, unlocked position.
3. To go forward, slowly push the motion-control
levers forward (Figure
Figure 24
EUTRAL
20).
24).
G008952
g008952
Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion-control
levers rearward
Using the Smart Speed
Control System
The Smart Speed TM
the right of the operating position
you a choice to drive the machine at 3 ground speed
ranges—trim, tow, and mow.
1. Smart-speed lever
To change speeds, do the following:
1. Move the motion-control levers to neutral and
outward to the N
2. Disengage the blade-control switch.
23
(Figure 25).
G008953
Figure 25
Control-System lever, located to
(Figure 26), gives
Figure 26
-L position.
EUTRAL OCK
g008953
TM
g197125