Toro 75210 Operator's Manual page 12

Choke Control
Use the choke control to start a cold engine. Pull the
choke control up to engage it. Push down on the
choke control to disengage it.
Hour Meter
The hour meter records the number of hours the
engine has operated. It operates when the engine
is running. Use these times for scheduling regular
maintenance (Figure 5).
Motion-Control Levers
The motion-control levers are speed-sensitive controls
of independent wheel motors. Moving a lever forward
or backward turns the wheel on the same side forward
or in reverse; wheel speed is proportional to the
amount the lever is moved. Move the control levers
outward from the center to the N
and exit the machine (Figure
motion-control levers into the N
when you stop the machine or leave it unattended.
Parking-Brake Lever
The parking-brake lever is located on left side of
the console (Figure 4). The brake lever engages a
parking brake on the drive wheels.
To engage the parking brake, pull up the lever until it
latches into the detent slot.
To disengage the parking brake, pull the lever out of
the detent slot and toward you, then push it down.
Foot Pedal Deck-Lift System
The foot pedal deck-lift system allows you to lower
and raise the deck from the seated position. You
can use the foot pedal to lift the deck briefly to avoid
obstacles or lock the deck in the highest height of cut
or transport position (Figure
Smart Speed™ Control System
Lever
The Smart Speed™ Control-System lever, located
below the operating position, gives you a choice to
drive the machine at 3 speed ranges— trim, tow, and
mow (Figure 26).
12 V Power Point
Use the power point to power 12 V accessories
(Figure 5).
-L position
EUTRAL OCK
4). Always position the
-L position
EUTRAL OCK
4).
Important:
When not using the 12 V power point,
insert the rubber plug to prevent damage to the
power point.
Ignition Switch
Use this switch to start the mower engine. It has 3
positions: S , R
TART
Blade-Control Switch (Power
Takeoff)
The blade-control switch (PTO) engages and
disengages power to the mower blades
Height-of-Cut Lever
The height-of-cut lever works with the foot pedal to
lock the deck in a specific cutting height. Only adjust
the height of cut while machine is not moving
4).
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
12
, and O .
UN FF
(Figure 5).
(Figure