Removing The Mower Deck - Toro 75210 Operator's Manual

Figure 62
1. Deck-lift arm
2. Chain
6. Ensure that there is tension on all 4 chains
(Figure 62).
7. Tighten the 4 adjustment bolts
8. Ensure that the blocks fit snugly under the deck
skirt and that all bolts are tight.
9. Verify that the deck is level by checking the
side-to-side level and front-to-rear blade slope;
repeat the deck leveling procedure if necessary.

Removing the Mower Deck

Park the machine on a level surface, disengage the
blade-control switch, move the motion-control levers
outward to the N
EUTRAL
parking brake, shut off the engine, remove the key,
and wait for all moving parts to stop before leaving the
operating position.
Lower the mower to the lowest height of cut. Select 1
of the following procedures depending on the mower
deck size installed to complete the removal.
Preparing to Remove the Mower
Deck
1. Lower the mower to the 76 mm (3 inches)
height-of-cut position.
2. Remove the mower belt from the engine pulley;
refer to Replacing the Mower Belt (page
3. Hook
4. Adjustment bolt
(Figure 62).
-L position, engage the
OCK
47).
Removing the Mower Deck
1. Remove the hairpin cotter and washer securing
the link pin to the frame and deck, and remove
the link bar
1. Link pin
g024313
2. Washer
2. Lift up the mower deck to relieve tension from
the mower deck.
3. Remove the chains from the hooks on the
deck-lift arms
1. Deck-lift arm
2. Chain
4. Raise the height of cut to the transport position.
5. Remove the belt from the clutch pulley on the
engine.
6. Slide the mower out from underneath the
machine.
Note:
Retain all parts for future installation.
45
(Figure 63).
Figure 63
3. Hairpin cotter
(Figure 64).
Figure 64
3. Hook
4. Adjustment bolt
g028276
g024313