Mower Belt Maintenance; Inspecting The Belts; Replacing The Mower Belt - Toro 75210 Operator's Manual

Hide thumbs Also See for 75210:
Table of Contents

Advertisement

4. Install the spring onto the straight end of the rod.
5. Position the spring on the rod as shown in so
the shorter spring end is coming from under the
rod before the bend and going over the rod as it
returns from the bend.
6. Lift the loop end of the spring and place it into
the notch on the deflector bracket
Figure 66
1. Rod and spring assembly
installed
2. Loop end of the spring
installed into the notch in
the deflector bracket
7. Secure the rod and spring assembly by twisting
it so the short end of the rod is placed behind
the front bracket welded to the deck
Important:
The grass deflector must be
spring loaded in the down position. Lift the
deflector up to test that it snaps to the full
down position.
(Figure
66).
2
1
3
4
g017618
3. Rod (short end) moved
behind mower bracket
4. Short end, retained by
mower bracket.
(Figure

Mower Belt Maintenance

Inspecting the Belts

Service Interval: Every 25 hours—Check the belts
Check the belts for cracks, frayed edges, burn marks,
or any other damage. Replace damaged belts.

Replacing the Mower Belt

Squealing when the belt is rotating, blades slipping
when cutting grass, frayed belt edges, burn marks,
and cracks are signs of a worn mower belt. Replace
the mower belt if any of these conditions are evident.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the mower to the 76 mm (3 inches)
height-of-cut position.
4. For each of the belt covers, loosen the 2 bolts,
but do not remove them.
5. Slide the cover until it is clear of the bolts and lift
it up and out to remove it.
g017618
6. Remove the floor pan to access the idler pulley.
7. Using a spring removal tool, (Toro Part No.
92-5771), remove the idler spring from the
deck post to remove tension on the idler pulley
(Figure
67).
66).
47
for wear or cracks.
EUTRAL
-L
OCK

Advertisement

Table of Contents
loading

This manual is also suitable for:

Timecutter hd myride

Table of Contents