Connecting To The Projector - Projectiondesign F1+ Protocol Manual

.

Connecting to the projector

You have two options regarding how to make the physical connection to the projector.
You can either use a crossover twisted pair (TP) cabel directly from the computer to the
projector, or two straight-through TP cables with a HUB or a switch between them.
Now the computer should be on the same subnet as the projector, and you are ready to
configure it. This is done by starting up an internet browser, like Internet Explorer, Opera,
Firefox or similar. Then type the projectors default IP address (192.168.1.90) in the address
bar.
You will then be presented with the login screen shown below:
6
Type in the projectors default login name (admin) and password (admin), both are case
sensitive.
If both are correct, you will se a configuration website like this:
On this page you can setup the projectors IP address, subnet mask, default gateway,
projector port (TCP), rimi port (UDP), and password. This page also displays the current
version of network firmware the projector is running.