How To Use The Projectors Lan Functionality - Projectiondesign cineo Supplementary Manual

3 HOW TO USE THE PROJECTORS LAN FUNCTIONALITY

Once the projector is setup correctly and connected to the LAN, it's ready to receive
commands. The LAN commands is exactly the same as for RS232 control, although you
may have to pass on the commands to the projector with a different application.
HyperTerminal that comes with Windows, can be used for this.
- Start up HyperTerminal, click "File" and
then "New Connection". Give it a name
and press OK. You will then see this dia-
log, here you choose TCP/IP (Winsock).
- Now type in the projectors IP address in
the "Host address:" field, and the projec-
tors TCP port in the "Port number:" field.
Press OK when you're done.
To send an eOperation to the projector, select
"Transfer" and then "Send Text File...".
You will then be presented with a dialog which you can choose the file you want to trans-
fer. Choose your command, click "Open", and the command will be transfered.
Other network options:
As you can see from the default settings table, the projectors also support commands over
the UDP protocol. HyperTerminal doesn't support UDP but there are other applications like
the ones from SimpleComTools.
There is also quite easy to integrate this functionality if you are designing an application
yourself.
With a Crestron, AMX and other control system you now have the option to control the
projector via Ethernet in addition to RS232 using the same command set.
7