Advertisement
INSTALLATION GUIDE FOR CLF7L, CLF11L JOINED
SAFETY PRECAUTIONS
WARNING - Risk of fire or electric shock. Basic safety precautions should always be
followed when using electrical equipment.
WARNING - This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of the
product and the hazards involved.
WARNING - Disconnect power to all circuits before wiring fixture.
WARNING - Install in accordance with all national, state, and local codes.
WARNING - Do not connect to an ungrounded supply.
WARNING - Read all fixture markings and labels to ensure correct installation of
fixture.
WARNING – Do not apply power to the fixture until the LED Board assembly is
connected to the driver. If power is applied to the fixture prior to connecting the LED
Board assembly to the driver, this will cause the LED Board to fail and void the
warranty.
RETAIN THESE INSTRUCTION FOR FUTURE USE
One Lithonia Way, Conyers GA 30012 | 1.800.705.SERV (7378) |
www.luminaireled.net
| © 2020 Acuity Brands Lighting, Inc. All rights reserved.
Page 1 of 3
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Luminaire led CLF11L
Summary of Contents for Luminaire led CLF11L
- Page 1 INSTALLATION GUIDE FOR CLF7L, CLF11L JOINED SAFETY PRECAUTIONS WARNING - Risk of fire or electric shock. Basic safety precautions should always be followed when using electrical equipment. WARNING - This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
- Page 2 INSTALLATION GUIDE FOR CLF7L, CLF11L JOINED CAN ICES-005 (A) / NMB-005 (A) FCC COMPLIANCE STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 3 INSTALLATION GUIDE FOR CLF7L, CLF11L JOINED Lens Joiner Band Housing End Cap 8-32 Screws INSTALLATION PROCEDURE 1. Remove Luminaires from carton and inspect for damage. 2. Remove End Caps via (2) 8-32 screws each. 3. Remove Joiner Bands via (2) 8-32 screws.
Need help?
Do you have a question about the CLF11L and is the answer not in the manual?
Questions and answers