1. Manuals
  2. Brands
  3. Luminaire led Manuals
  4. Lighting Equipment
  5. TSL9 LED Series
  6. Installation manual

Luminaire led TSL9 LED Series Installation Manual

Hide thumbs
1
2
3

Advertisement

Table of Contents

INSTALLATION GUIDE FOR
TSL9 LED SERIES

SAFETY PRECAUTIONS

WARNING - Risk of fire or electric shock. Basic safety precautions should always be
followed when using electrical equipment.
WARNING - This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of the
product and the hazards involved.
WARNING - Disconnect power to all circuits before wiring fixture.
WARNING - Install in accordance with all national, state, and local codes.
WARNING - Do not connect to an ungrounded supply.
WARNING - Read all fixture markings and labels to ensure correct installation of
fixture.
RETAIN THESE INSTRUCTION FOR FUTURE USE
One Lithonia Way, Conyers GA 30012 | 1.800.705.SERV (7378) |
www.luminaireled.net
| © 2020 Acuity Brands Lighting, Inc. All rights reserved.
Page 1 of 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TSL9 LED Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Luminaire led TSL9 LED Series

Summary of Contents for Luminaire led TSL9 LED Series

  • Page 1 INSTALLATION GUIDE FOR TSL9 LED SERIES SAFETY PRECAUTIONS WARNING - Risk of fire or electric shock. Basic safety precautions should always be followed when using electrical equipment. WARNING - This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
  • Page 2 INSTALLATION GUIDE FOR TSL9 LED SERIES CAN ICES-005 (A) / NMB-005 (A) FCC COMPLIANCE STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
  • Page 3 INSTALLATION GUIDE FOR TSL9 LED SERIES Lens Endcap Sensor Controls INSTALLATION PROCEDURE 1. Remove Luminaire from carton and inspect for damage. 2. Remove End Caps. 3. Remove Lens via 8-32 screws. 4. Remove LED Board Assembly by loosening (2) ¼ hex screws.

Table of Contents