1. Manuals
  2. Brands
  3. Luminaire led Manuals
  4. Lighting Equipment
  5. LVP751
  6. Installation manual

Luminaire led LVP751 Installation Manual

Hide thumbs
1
2
3

Advertisement

Table of Contents

INSTALLATION GUIDE FOR LVP751 LED

SAFETY PRECAUTIONS

WARNING - Risk of fire or electric shock. Basic safety precautions should always be
followed when using electrical equipment.
WARNING - This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of the
product and the hazards involved.
WARNING - Disconnect power to all circuits before wiring fixture.
WARNING - Install in accordance with all national, state, and local codes.
WARNING - Do not connect to an ungrounded supply.
WARNING - Read all fixture markings and labels to ensure correct installation of
fixture.
WARNING – Do not apply power to the fixture until the LED Board assembly is
connected to the driver. If power is applied to the fixture prior to connecting the LED
Board assembly to the driver, this will cause the LED Board to fail and void the
warranty.
RETAIN THESE INSTRUCTION FOR FUTURE USE
One Lithonia Way, Conyers GA 30012 | 1.800.705.SERV (7378) |
www.luminaireled.net
| © 2020 Acuity Brands Lighting, Inc. All rights reserved.
Page 1 of 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LVP751 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Luminaire led LVP751

Summary of Contents for Luminaire led LVP751

  • Page 1 INSTALLATION GUIDE FOR LVP751 LED SAFETY PRECAUTIONS WARNING - Risk of fire or electric shock. Basic safety precautions should always be followed when using electrical equipment. WARNING - This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
  • Page 2 INSTALLATION GUIDE FOR LVP751 LED CAN ICES-005 (A) / NMB-005 (A) FCC COMPLIANCE STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
  • Page 3 INSTALLATION GUIDE FOR LVP751 LED Mounting Points (6) INSTALLATION PROCEDURE 1. Remove Luminaire from carton and check for damage 2. Remove (6) 8-32 Tamper resistant screws with provided bit. 3. Remove Lens 4. Set aside screws and lens for later use.

Table of Contents