Keysight Technologies N52 Series User's And Service Manual page 42

Installation & System Operation
The following detailed instructions are for connecting an OML T/R module.
These instructions assume a cable dress kit (black sleeving) is available. Modify
the instructions appropriately for other types of modules.
1. Prepare the cable bundle comprised of five cables listed in
2. Connect the five cables to the front panel of the controller in the following
Table 1-13 Controller Connections
Order
1
2
3
4
5
Figure 1-25 Controller Front Panel Connections
3. Repeat
Keysight N5261/62A User's & Service Guide
a. Complete Steps 1 through 5 of the Installation Guide from the
Millimeter-wave Cable Dress Kit (document number N5260-90070
contained in kit part number N5261-60019). DO NOT APPLY THE
VELCRO ASSEMBLIES AT THIS TIME.
order. Use two right angle adapters (1260-2604).
Test Set
DC POWER
TEST IF
REF IF
RF OUT
LO OUT
and
step 1 step 2
Module (OML)
+12 V
Test I.F.
Ref I.F.
R.F. In
L.O. In
for each module in the system.
Table 1-13.
37