Charging The Batteries - Pro-Team GoCartVac User Manual

OFF

CHARGING THE BATTERIES

1. Make sure the power switch is in the off (0) position (Figure A).
2. Plug extension cord into cord plug outlet on the back of machine (Figure B).
3. Plug power supply into 120 V wall outlet (Figure C).
4. Flip power switch to on (I) position. Charge for up to 3.5 hrs (Figure D).
OFF
Figure A
WARNING
The switch should be placed in the OFF (0) position when
plugging and unplugging the extension cord into a wall outlet
You may vacuum with the GoCartVac plugged into the wall outlet. The batteries
will recharge while you vacuum. The average recharge time depends on how low
the battery level is. If the battery is completely depleted, the recharge time is
approximately 3.5 hours.
The GoCartVac is equipped with a solid state detector which monitors the Charge
state of the batteries. The detector will automatically turn the vacuum OFF when
the battery voltage falls below 33 Volts DC. This detector has been implemented
to prevent the batteries from being overly discharged which reduces battery life and
results in prolonged recharge time.
PROPER STORAGE & CHARGING
1. When the vacuum is not in use, it should be stored in a dry place.
2. Plug the GoCartVac into the wall outlet so it is recharged for the next use.
3. Place the switch on the cart in the ON (I) position, or the batteries will
not recharge.
4. Wrap the hose around the hose wrap.
5. Loosley loop the extension cord over the cord wrap.
6. EMPTY OR REPLACE THE INTERCEPT MICRO FILTER AFTER EACH USE.
6
Figure B Figure C
ON
Figure D
.
ProTeam