Preparing The Vacuum For Operation - Pro-Team GoCartVac User Manual

PREPARING THE VACUUM
FOR OPERATION
1. Lift the cover off of the cart (
2. Set cover in tray on cart (
3. Unscrew the cap on the top of the vacuum unit (
3. Check to make sure the filters have not shifted during shipping (
Figure A
4. Replace filters and cap.
5. Replace cover plate and snap into position (
6. Insert hose securely into the twist cap of the vacuum (
7. Plug the control cord into the receptacle on the cart (
8. Attach wand to handle (
Figure E
9. The operation of the vacuum is controlled by the switch
located on the gas pump handle of the hose. This is a
alternating switch and must be turned on in order for the
vacuum to run. To maximize battery power remember to
turn the vacuum off when not in operation (
IF THE VACUUM DOES NOT OPERATE, PROCEED TO
"CHARGING BATTERY INSTRUCTIONS" ON PAGE 6
ProTeam
Figure A
).
Figure B
).
Figure B
Figure H
) and accessory to end of wand.
Figure F
(Battery Power)
Figure C
).
Figure C
Figure E
).
Figure F
Figure G
Figure G
Figure I
).
Figure D
).
Figure D
).
).
Figure H
Figure I
5