Specifications - 3M DBI-SALA Rollgliss 3303015 User Instruction Manual

Table of Contents

Advertisement

Step 4.
Device labels must be present and fully legible (see Section 8).
Step 5.
Inspect for corrosion on the device.
Step 6.
Inspect connecting hooks or carabiners for damage, corrosion, and working condition.
Step 7.
Inspect all system components and subsystems according to manufacturer's instructions.
Step 8.
Record inspection results in the Inspection and Maintenance Log (Section 9) or on the RFID web portal
(Section 5.2).
5.5
UNSAFE OR DEFECTIvE CONDITIONS: If inspection reveals an unsafe or defective condition, remove the device from
service and contact an authorized service center for repair.
6.0 MAINTENANCE, SERvICE, STORAGE
6.1
MAINTENANCE AND SERvICE: Periodically clean the exterior of the Emergency Descent Device with water and mild
detergent. Position the device so excess water can drain out. Clean labels as required. Clean device lifeline with water
and mild detergent. Rinse and thoroughly air dry. Do not force dry with heat. An excess buildup of dirt, paint, etc., may
prevent the lifeline from retracting back into the device.
Additional maintenance and servicing must be completed by an authorized service center. Do not attempt to disassemble
the device.
NOTE:
Only 3M Fall Protection or parties authorized in writing may make repairs to this equipment.
6.2
STORAGE AND TRANSPORT: Store and transport the Emergency Descent Device in a cool, dry, clean
environment, out of direct sunlight. Avoid areas where chemical or organic vapors are present. Thoroughly inspect the
Emergency Descent Device after extended storage.

7.0 SPECIFICATIONS

7.1
MATERIALS
Housing:
Anchorage Handle:
Fasteners:
Main Shaft:
Connecting Hook:
Cable Bumper:
Lifeline (Stainless Steel):
Finish Paint:
7.2
PERFORMANCE SPECIFICATIONS
Capacity:
Nominal Descent Speed:
Cast Aluminum
Stainless Steel
Stainless Steel
Stainless Steel
Stainless Steel
Urethane
3/16" (4.8 mm) dia. 7x19 Aircraft Wire Rope, 3,600 lbs (16 kN)
minimum tensile strength
Polyester Baked Finish
1 user - 75-310 lbs (34-141 kg)
6 ft/sec (1.8 m/s)
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dbi-sala rollgliss 3303016

Table of Contents