Hyundai HSO14210 Original Instructions Manual page 5

guarding system. Without turning the tool "ON" and with no workpiece on the table, move the saw blade
through a complete simulated cut to assure there will be no interference or danger of cutting the fence.
NOTE: the phrase "bevel or" does not apply for saws without bevel adjustment.
Provide adequate support such as table extensions, saw horses, etc. for a workpiece that is
l)
wider or longer than the table top. Workpieces longer or wider than the mitre saw table can tip if not
securely supported. If the cut-off piece or workpiece tips, it can lift the lower guard or be thrown by the
spinning blade.
Do not use another person as a substitute for a table extension or as additional support.
m)
Unstable support for the workpiece can cause the blade to bind or the workpiece to shift during the cutting
operation pulling you and the helper into the spinning blade.
The cut-off piece must not be jammed or pressed by any means against the spinning saw
n)
blade. If confined, i.e. using length stops, the cut-off piece could get wedged against the blade and thrown
violently.
Always use a clamp or a fixture designed to properly support round material such as rods or
o)
tubing. Rods have a tendency to roll while being cut, causing the blade to "bite" and pull the work with your
hand into the blade.
p) Let the blade reach full speed before contacting the workpiece. This will reduce the risk of the
workpiece being thrown.
If the workpiece or blade becomes jammed, turn the mitre saw off. Wait for all moving parts to
q)
stop and disconnect the plug from the power source and/or remove the battery pack. Then work to
free the jammed material. Continued sawing with a jammed workpiece could cause loss of control or
damage to the mitre saw.
After finishing the cut, release the switch, hold the saw head down and wait for the blade to
r)
stop before removing the cut-off piece. Reaching with your hand near the coasting blade is dangerous.
Hold the handle firmly when making an incomplete cut or when releasing the switch before the
s)
saw head is completely in the down position. The braking action of the saw may cause the saw head to
be suddenly pulled downward, causing a risk of injury.
1.3 ADDITIONAL INSTRUCTIONS
- When using the saw, wear personal protective equipment such as safety goggles or a screen, helmet,
dust mask, gloves, non-slip footwear and protective clothing
- Ensure that there is sufficient, generalized or localized lighting.
- Do not use the saw when the protective parts are not in place.
- Do not use the saw to cut metal or masonry parts.
- Do not allow persons under 18 to operate the tool.
- Ensure that users of this tool have received professional training and know how to set and use this tool.
- Do not use the saw to cut firewood
- Remove all stumbling blocks from the work area.
- Report or record any defects as soon as possible, including the guards and the saw blade.
- Install the saw as much as possible on a work stand. Always stay on the side when the saw is turning.
- Never use a saw blade that is cracked or deformed.
- When cutting round wood, use a clamping assembly to prevent slippage of the workpiece.
- Do not use your hand to remove sawdust, chips or debris near the saw blade.
- Use only blades recommended by the manufacturer that comply with EN847-1.
- Do not use high speed steel blades (HSS blades).
- If the plate inserted on the swivel table is worn or damaged, have it replaced by an authorized service
center
- Objects such as cloth, strings, should never be left in the working zone. Avoid cutting nails. Check the
workpiece and remove all nails and other foreign objects before starting the machine.
- Hold the workpiece firmly.
- Avoid collecting debris or sawdust on the saw before the saw is completely stopped and the blade guard
is in the open position.
- Do not attempt to release a blocked blade before stopping the machine by pressing the switch
- Do not attempt to slow down or stop the blade when it is still in the workpiece.
- Let the machine stop by itself.
05