Hyundai HSO14210 Original Instructions Manual page 15

6.4 CROSSCUT 90° AND TURNTABLE 0° - 45° (FIG. 1/7/8)
The mitre saw can be used to make crosscuts of 0°-45° to the left and 0°-45° to the right in relation to the
stop rail.
Important! For 90° crosscuts, the moveable stop rail (16a) must be fixed in the inner position.
Open the set screw (16b) for the moveable stop rail (16a) and push the moveable stop rail (16a) in-

wards.
The moveable stop rail (16a) must be fixed far enough in front of the innermost position that the

distance between the stop rail (16a) and the saw blade (6) amounts to a minimum of 8 mm.
Before making the cut, check that the stop rail (16a) and the saw blade (6) cannot collide.

Secure the set screw (16b) again.

Loosen the set screw (10).

Use the handle (1) to adjust the rotary table to the desired angle.

The pointer (11) on the rotary table must match the desired angle on the scale (12) on the fixed saw

table (14).
Re-tighten the set screw (10) to secure the rotary table (13).

Cut as described under section 6.3.

6.5 PRECISION ADJUSTMENT OF THE STOP FOR MITRE CUT
45° (FIG. 1/2/5/9/10)
No stop angle included.

Lower the machine head (4) and secure it using the locking bolt (21).

Fix the rotary table (13) in the 0° position.

Attention! For mitre cuts (inclined saw head), the moveable stop rails (16a) must be fixed in the outer
position.
Open the set screw (16b) for the moveable stop rail (16a) and push the moveable stop rail (16a) out-

wards.
The moveable stop rail (16a) must be fixed far enough in front of the innermost position that the

distance between the stop rail (16a) and the saw blade (6) amounts to a maximum of 8 mm.
Before making a cut, check that the stop rail (16a) and the saw blade (6) cannot collide.

Loosen the set screw (20) and use the handle (1) to angle the machine head (4) 45° to the left.

Position angle stop (B) between the saw blade (6)

Loosen the lock nut (25a) and adjust the adjustment screw (25) until the angle between the saw blade

(6) and the rotary table (13) is precisely 45°.
Re-tighten the lock nut (25a).

Subsequently check the position of the angle indicator. If necessary, loosen the pointer (19) using a

Philips screwdriver, set to position 45° on the angle scale (18) and re-tighten the retaining screw.
6.6 MITRE CUT 0°- 45° AND TURNTABLE 0° (FIG. 1/2/11)
The mitre saw can be used to make mitre cuts of 0°- 45° in relation to the work face.
Attention! For mitre cuts (inclined saw head), the moveable stop rails (16a) must be fixed in the outer
position.
Open the set screw (16b) for the moveable stop rail (16a) and push the moveable stop rail (16a) out-

wards.
The moveable stop rail (16a) must be fixed far enough in front of the innermost position that the

distance between the stop rail (16a) and the saw blade (6) amounts to a minimum of 8 mm.
Before making a cut, check that the stop rail (16a) and the saw blade (6) cannot collide.

Secure the set screw (16b) again.

Move the machine head (4) to the top position.

and rotary table (13).
15