Specifications; Operation; Filling The Fuel Tank - Toro DH 220 Operator's Manual

Specifications

Weight
Length
Width
Cutting Width
Height
Engine Speed
Nominal Engine Power
256 kg
260 cm
110 cm
102 cm
119 cm
2,600 rpm
12.1 Kw at 3,000 rpm

Operation

Note:
Determine the left and right sides of the
machine from the normal operating position.

Filling the Fuel Tank

•
For best results, use only clean, fresh (less than
30 days old), unleaded gasoline with an octane
rating of 87 or higher ((R+M)/2 rating method).
•
Ethanol: Gasoline with up to 10% ethanol
(gasohol) or 15% MTBE (methyl tertiary butyl
ether) by volume is acceptable. Ethanol and
MTBE are not the same. Gasoline with 15%
ethanol (E15) by volume is not approved for use.
Never use gasoline that contains more than
10% ethanol by volume, such as E15 (contains
15% ethanol), E20 (contains 20% ethanol), or E85
(contains up to 85% ethanol ). Using unapproved
gasoline may cause performance problems and/or
engine damage which may not be covered under
warranty.
•
Do not use fuel containing methanol.
•
Do not store fuel either in the fuel tank or fuel
containers over the winter unless a fuel stabilizer
is used.
•
Do not add oil to the fuel.
Important:
To reduce starting problems, add fuel
stabilizer to the fuel all season, mixing it with fuel
less than 30 days old; run the machine dry before
storing it for more than 30 days.
Do not use fuel additives other than a fuel
stabilizer/conditioner. Do not use fuel stabilizers
with an alcohol base such as ethanol, methanol,
or isopropanol.
DANGER
Fuel and fuel vapors are extremely flammable
and explosive. A fire or explosion from fuel
can burn you and others.
• To prevent a static charge from igniting the
fuel, place the container and/or machine
directly on the ground before filling, not in
a vehicle or on an object.
• Fill the tank outdoors when the engine is
cold. Wipe up spills.
• Do not handle fuel when smoking or
around an open flame or sparks.
• Store fuel in an approved fuel container,
out of the reach of children.
1. Stop the engine and wait for all moving parts to
stop.
11