Table of Contents
Advertisement
TOC
6. Connect the other end of the
the Laminator's rear-panel
Figure 7: Connecting the Laminator Control Cable
7. Apply power to the Laminator by connecting the
Laminator's Power Supply cord to the Laminator's rear-
panel
suitable wall outlet.
8. Press the
9. Turn the Laminator off. This will allow for easier
calibration.
10. With the Laminator Tray out and the Laminator turned off,
apply power to ADL-100 by plugging in the cord on the
other side of the Power Adapter to a suitable wall outlet.
B.
CALIBRATION
Please note:
To calibrate the laminator to the ADL-100, the Laminator's
Disc Tray should be in the out position and the Laminator
should be off.
1. Load the
Output Bin
2. Press the
over the Input Bin and the Output Arm should move over
to the top of the Accent Tray.
3. Place a CD on the fingers of the Input AND Output Arms.
4. With the Accent tray extended and the Accent turned off,
press and hold the
move the Output Arm down to the Laminator's CD tray.
Power Input
Port. Connect the other end to a
Laminate Button
Input Bin
with at least 4-5 CDs and place the
in the proper location.
Sequence
Button. The Input Arm should move
Pick Button
INDEX
Laminator Control Cable
6-pin mini-DIN
port.
to eject the Laminator Tray
for 5 seconds. This will
Hardware and Cable Set-Up 5
to
Advertisement
Table of Contents
