Page 1
040604-510896-(01) ADL-100 Operator’s Manual For Use With the Accent Disc Laminator 2004 All rights reserved.
Page 2
Notices: The information in this document is subject to change without notice. NO WARRANTY OF ANY KIND IS MADE WITH REGARD TO THIS MATERIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. No liability is assumed for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material.
ADL-100 will automatically and effortlessly transport anything from a just a few CDs to hundreds or thousands of discs per day. The ADL-100 is suitable for use in office or production environments and fits conveniently on any desktop.
IDENTIFYING THE PARTS Illustrated in Figure 1 is the ADL-100 with an Accent Disc Laminator attached. Figure 2 shows the rear panel of ADL-100. Front Panel and Top Output Bin ADL-100 Figure 1: ADL-100 and Accent Disc Laminator Rear Panel...
Section 2: Hardware and Cable A. CONNECTING THE PARTS AND INTERFACE CABLES Follow these steps to integrate your ADL-100 and Laminator: 1. In the ADL-100 shipping box you will find the Output Bins. Place the Bins in their correct places as shown in Figure 1.
Page 8
4. Attach the connecting tabs and inserting them into the appropriate slots on the rear panel of the ADL-100. Figure 5: Attaching the Laminator Stand Make sure that the out the back of the Laminator Stand so that it can be connected to your Laminator.
9. Turn the Laminator off. This will allow for easier calibration. 10. With the Laminator Tray out and the Laminator turned off, apply power to ADL-100 by plugging in the cord on the other side of the Power Adapter to a suitable wall outlet. CALIBRATION...
100 printed discs, press the Laminator's Laminate ADL-100 will load a disc into the Laminator. Once the Laminator has reached operating temperature, the disc will laminate. While the disc is laminating, the ADL-100 will pick the next disc.
B. PAUSE LED Status On Solid Flashing Status Lights Lights, located on ADL-100's front panel, can Condition No Power. Plug in Power Adapter. Power is ON. This is ADL-100's normal "waiting" mode. Power is ON, but an error condition exists: a.
Section 4: ADL-100 is designed to operate for extended periods of time with very little attention. In fact, no regular maintenance is recommended other than cleaning the outside case. IMPORTANT: Do NOT attempt to oil or grease the ADL-100's Robotic Arm shaft or other components.
Weight Dimensions (with Accent attached) Certifications Warranty INDEX Specifications ADL-100 Autoloader for use with the Accent Disc Laminator Controlled by Primera Technology Disc Laminator 100 disc input, 100 disc output 100-240 VAC, 50/60 Hz, 60 watts 8.9 lbs. (4.04 kg) 16.625"W x 14"H x 10.125"D...