Section 2: Hardware And Cable Set-Up; Connecting The Parts And Interface Cables - Primera ADL-100 Operator's Manual

TOC
Section 2: Hardware and Cable
A. CONNECTING THE PARTS AND INTERFACE CABLES
Follow these steps to integrate your ADL-100 and Laminator:
1. In the ADL-100 shipping box you will find the
Output
shown in Figure 1.
2. Connect the
with your
rear panel
end yet.
Figure 3: Connecting the Laminator Control Cable
3. Apply power to the ADL-100 by connecting the
Supply cord
Don't plug the other end into a wall outlet yet.
Figure 4: Connecting Power to ADL-100
Set-Up
Bins. Place the Bins in their correct places as
Laminator Control Cable
Laminator Stand. Insert it into the ADL-100
6-pin mini-DIN
to the AD-100's rear-panel
INDEX
that was included
socket. Don't connect the other
Power Input
Hardware and Cable Set-Up 3
Input and
Power
Port.