Table of Contents
Advertisement
Notices: The information in this document is subject to change without notice. NO
WARRANTY OF ANY KIND IS MADE WITH REGARD TO THIS MATERIAL,
INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. No liability is
assumed for errors contained herein or for incidental or consequential damages in
connection with the furnishing, performance, or use of this material. This document
contains proprietary information that is protected by copyright. All rights are reserved.
No part of this document may be photocopied, reproduced, or translated into another
language without prior written consent.
Trademark Acknowledgments: Windows is a registered trademark of Microsoft
Corporation. All other trademarks are the property of their respective owners.
Printing History
Edition 1.0, # 040604
FCC Compliance Statement: This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
For Users in the United States: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cables is required to comply with the Class B limits of Part 15 of the FCC
Rules. You are cautioned that any changes or modifications not expressly approved in this
manual could void your authority to operate and/or obtain warranty service for this
equipment.
For Users in Canada: This digital apparatus does not exceed the Class B limits for radio
noise for digital apparatus set out on the Radio Interference Regulations of the Canadian
Department of Communications. Le present appareil numerique n'emet pas de bruits
radioelectriques depassant les limites applicables aux appareils numeriques de la class B
prescrites dans le Reglement sur le brouillage radioelectrique edicte par le ministere des
Communications du Canada.
CAUTION!
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN
OR MOISTURE. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
EXTERIOR PANELS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL. OPERATE THE UNIT WITH ONLY THE
PROPER ELECTRICAL SPECIFICATIONS AS LABELED ON THE LAMINATOR AND
AC ADAPTER.
ii
Advertisement
Table of Contents
