Your First Laminating Job - Primera ADL-100 Operator's Manual

TOC
5. Loosen the 3 screws on the top of the Accent Stand &
adjust the Accent so that the CD is as centered as possible
above the tray.
Figure 8: Adjusting the
6. Tighten the 3 screws.
7. Press Pick to end the adjustment mode
8. Turn on the Laminator.
You have completed the Calibration procedure and are now
ready to start your first print job!
C. YOUR FIRST LAMINATING JOB
Operation is really very simple. Once the ADL-100's
Bin has been loaded with up to 100 printed discs, press the
Laminator's
ADL-100 will load a disc into the Laminator. Once the
Laminator has reached operating temperature, the disc will
laminate. While the disc is laminating, the ADL-100 will pick
the next disc. Once the disc in the laminator is finished, the
ADL-100 will pick it from the Accent's tray, rotate, and
simultaneously deposit the finished disc into the
and load the next disc into the Laminator's tray. This continues
until the stack is completed.
6 Hardware and Cable Set-Up
Laminator Stand
Laminate Button. Once this is pressed, the
INDEX
Input
Output Bin