Table of Contents
Advertisement
TOC
Section 4:
ADL-100 is designed to operate for extended periods of time
with very little attention. In fact, no regular maintenance is
recommended other than cleaning the outside case.
IMPORTANT:
A. CLEANING THE CASE
Use a clean, white rag with a small amount of water or
isopropyl alcohol to clean the ADL-100 and Laminator's
outside cases and CD trays. Stronger cleaning solutions are
NOT recommended because they may damage the paint and
plastic materials from which the parts are manufactured.
Always disconnect your ADL-100 and Laminator power cords
before cleaning. Resume operation only after the surfaces are
completely dry.
B.
RESETTING THE ROBOTICS
If you find yourself in a situation where the robotics are not
responding properly, you may need to do a system reset. A
typical cause may be when you stop a job out of sequence. To
do so, press the
release.
C.
TECHNICAL SUPPORT
If you have difficulties in operating your ADL-100, the set-up
and testing procedures in this manual should, in most cases,
solve the problem. If you still have difficulty, contact the
technical support number listed on the insert included in the
supply pack that came with your product.
8 Maintenance and Troubleshooting
Maintenance
Troubleshooting
Do NOT attempt to oil or grease the ADL-100's Robotic
Arm shaft or other components. You will likely cause
more harm than good! Any moving parts are designed
to be run for the life of the machine with no additional
lubrication required.
Pause and Pick Buttons
INDEX
and
at the same time then
Advertisement
Table of Contents
