Wall Mounting - Bosch GAL18V-20 Operating/Safety Instructions Manual

FIG. 2
mounting hardware prior to drilling hole.
Note: The consumer is responsible for damage or
injury caused by incorrect installation.
Use mounting hardware which is appropriate
for the wall type and suitable for the weight
of charger and heaviest battery pack. If the
charger is installed without the correct hardware,
the product may be unstable and cause property
damage or personal injury.
Do not wall mount the charger where the weight
of the charger and battery cannot be supported.
If the strength of the wall mount location is not
strong enough, the charger can fall off and cause an
injury. Note: It is the consumer's responsibility to
ensure that the wall can properly support the total
weight.
Check to be sure that there are no hidden
live wires, water pipe, or gas pipe behind the
mounting area. Cutting or drilling into any of these
may cause serious injury or death.
vertical wall. Mounting of the charger is
designed for vertical surfaces only. Improper
installation may cause property damage or personal
injury.

Wall Mounting

Read instructions of the
drill driver and the
Do not mount to any
sur face other than a
The charger can be mounted to a wall using wall
mounting slots 4 (Fig. 2).
a. Locate mounting area on the wall.
b. Mark two points on a vertical line 2.84"
(72mm) apart.
c. Select the appropriate screws and anchors
(if necessary) for the material of the wall.
(Mounting hardware not included.)
d. Drill into wall with appropriate drill bit.
If anchors are to be used, follow anchor
hardware manufacturer's instructions.
e. Screw in two round-head screws (not
included) with a diameter of 0.2" (5mm)
to maximum 0.25" (6.5mm) into wall or
anchors. Leave approximately 0.13" (3.3
mm) space between bottom of screw head
and wall.
f. Position the charger screw slots over the
mounting screws. Push charger towards the
wall and slide it down to secure charger to
mounting screws.
Note: Make sure the charger is securely mounted
and that it is tight against the mounting surface.
Adjust screw exposure as necessary to ensure the
charger is flat against the wall.
-7-