Primera Bravo II User Manual page 16

TOC
INDEX
Publisher is attached properly and being seen by the server. You
should see the following message:
If you do not see this message, close the server software and
check the Publisher connection. Make certain the Publisher has
been installed properly on this system. Consult the Publisher's
User's Manual for troubleshooting tips on this Click OK to
return to the Options/Services Window. You can also test the
robotics of the Publisher by clicking the Movements Test button.
Pressing this button will open the Duplicator Movements
window.
In this window you will be able to reset the Robotics by pressing
the Reset Robotics button. This will clear the commands from
the internal memory and reset its processor. You can also
perform a test of the Publisher by selecting a number of discs
and clicking the Start Test button. This will cause the Publisher
to load discs, one at a time, from the input bin into the recorder,
then to the printer, and finally to the output. Click Exit to return
to the Options/Services window.
In to the Options/Services Window you will also see a button
that launches the SureThing CD labeler and will allow you to
create a disc design. If you use this, make certain you close
SureThing. It is very important that you do not have SureThing
running on the server while it is accepting jobs. If SureThing is
running when the server attempts to print, the job will fail.
12 Setting up the PTBurn Server