Table of Contents
Advertisement
TOC
•
Load the
of the Publisher) with 25 blank discs and place the bins on
the mounting pegs.
Step 3: Installing Ink Cartridges
• Press the Ink Cartridge Button
Cartridge Carrier to the load position and open the ink
cartridge covers
• Remove each ink cartridge from its packaging
• Slowly remove the tape covering
the cartridge's print head, being
careful to avoid damaging the
barcode label on the underside of
the cartridge.
DO NOT TOUCH THE COPPER AREA!
• Insert the ink cartridges into the carrier, copper end first
and snap the cartridge cover in place. Insert the color
in the left holder, monochrome black in the right
cartridge holder.
• Close the Publisher's front cover.
Step 4: Connecting the FireWire Cable
The black IEEE 1394 FireWire cable carries the data that will be
sent to the recorder when producing discs. If necessary, install
a compatible FireWire board in your PC. Please refer to the
manufacturers instructions for proper installation of the
FireWire board. Connect the 6 Pin FireWire cable included with
your Publisher. Connect the other end to the FireWire board's
output port on your PC.
10 Hardware and Software Set-Up
Input Bin
(the bin located on the right-hand side
INDEX
to move the Ink
Color
Black
Advertisement
Table of Contents
