How To Set The Auto Restart Function; Power Failure During Timer Operation - Toshiba RAS-25G3KVSG-ND Service Manual

9-3-2. How to Set the Auto Restart Function

To set Auto Restart Function, proceed as follows:
1. The power supply to the unit must be ON ; The function will not set or reset if the power supply is OFF.
2. Press the [RESET] button located on the front panel of the indoor unit for more than 3 seconds.
3. After 3 seconds, the unit beeps three times and the indicator blinks for 5 seconds.
• When the unit is standby (Not operating)
Operation
Press [RESET] button for more than
three seconds. (Less than 10 seconds)
OPERATION /
RESET Button
• When the unit is in operation
Operation
Press [RESET] button for more than
three seconds. (Less than 10 seconds)
OPERATION /
RESET Button

9-3-3. Power Failure During Timer Operation

When the unit is turned off because of power failure during timer operation, the timer operation is
cancelled. In that case, set the timer operation again.
NOTE :
The Daily Timer is reset while a command signal can be received from the remote controller even if it
stopped due to a power failure.
The unit is on standby.
↓
The unit starts to operate.
↓ After approx. three seconds,
The unit beeps three times
and continues to operate.
If the unit is not required to operate at this time, press [RESET]
button once more or use the remote controller to turn it off.
The unit is in operation.
↓
The unit stops operating.
↓ After approx. three seconds,
The unit beeps three times.
If the unit is required to operate at this time, press [RESET] button
once more or use the remote controller to turn it on.
- 50 -
Motions
The blue indicator is on.
The blue indicator flashes
for 5 seconds.
Motions
The blue indicator is on.
The blue indicator is turned off.
The blue indicator flashes
for 5 seconds.