Operation; Starting The Attachment - Toro 51810T Manual

Operation

Starting the Attachment

WARNING
Do not attempt to operate the power head
without an attachment installed.
Read and follow the Operator's Manual for
your specific attachment before operating the
power head.
1. Ensure that the vents on the attachment, power
head, and battery are clear of any dust and
debris.
2. Align the cavity in the battery pack with the
tongue on the handle housing
3. Push the battery pack into the handle until the
battery locks into the latch.
4. To start the attachment, press the lockout button,
then squeeze the run trigger
Note:
Slide the 2-speed switch to change the
speed of the attachment.
(Figure 6).
Figure 6
PRELIMINARY
(Figure 7).
1. Lockout button
2. 2-speed switch
Shutting Off the Attachment
To shut off the attachment, release the run trigger.
Whenever you are not using the attachment or are
transporting the trimmer to or from the work area,
remove the battery pack.
Removing the Battery Pack
from the Power Head
Press the battery latch on the machine to release the
battery pack and slide the battery pack out of the
machine (Figure
g357444
1. Battery latch
9
Figure 7
3. Run trigger
8).
Figure 8
g357456
g357457