4.8.4
Electrode position
Refer to Fig. 23.
4.9
Burner refitting
Refit the burner to the slide bars 3) (Fig. 24) at approximately
4" from the sleeve 4) - burner positioned as shown in (Fig. 12,
page 17) - insert the ignition electrode cables.
Remove the extension bars 31) Fig. 1, page 7.
Slide the burner up to the sleeve so that it is positioned as
shown in (Fig. 24);
refit screws 2) (Fig. 24) on slide bars 3) including the safety
plate 15) Fig. 12, page 17;
secure the burner to the sleeve by tightening screws 1);
connect the oil pipes again by screwing on the two connectors
6) (Fig. 12, page 17).
When fitting the burner on the two slide bars, it is
advisable to gently draw out the high tension cables
until they are slightly stretched.
WARNING
Installation
D10495
2
D10496
21
GB
1
4
3
5
6
14
3 / 3 2 "
Fig. 23
Fig. 24
20026897