Table of Contents
Advertisement
6.2
Opening the burner
6.2.1
To open the burner
To open the burner proceed sa follows:
switch off the electrical power;
loosen screws 1) and withdraw the cover 2);
disengage the swivel coupling 7) from the graduated sector;
disconnect the light-oil pipes 8);
remove screws 3) and pull the burner back by about 4" on the
slide bars. disconnect the electrode leads.
Install the extension bars 31) Fig. 1, page 7 and re-screw the
2 screws and the safety plate Fig. 12, page 17.
Pull the burner fully back.
Now extract the internal part 5) after having removed the screw 6).
D10502
20026897
Maintenance
6.2.2
To close the burner proceed sa follows:
push the burner until it is about 4" from the sleeve;
re-connect the leads.
Remove the extension bars 31) Fig. 1, page 7.
Slide in the burner until it comes to a stop;
refit screws 3) and pull the leads gently out until they are
re-couple the swivel coupling 7) to the graduated sector;
reconnect the light-oil pipes.
Re-screw the 2 screws and the safery plate Fig. 12, page 17.
1
2
34
GB
To close the burner
slightly stretched;
4
3
6
7
8
5
Fig. 48
Advertisement
Table of Contents
