Bosch JUNKERS UNIDOMO ELAFLUX ED 18-2 E Installation Instructions Manual page 12

How to operate the continuous-flow
heater
The warm water temperature can be continuously adjusted
on the electronically regulated flow-through heater:
With the use of a thermostat battery, the following settings
are recommended for high temperatures or large quantities
of water, for example:
Turn on the hot-water tap.
The continuous-flow heater switches on and heats the water
when the hot-water tap is turned on.
It switches off again when the tap is turned off. Changing
the supply water temperature correspondingly changes the
outgoing water temperature.
Increasing the water temperature
If a higher temperature for a completely opened warm water
tap is not achieved, more water flows than the flow-through
heater can warm as a result its performance capabilities. In
this case, the warm water tap must be closed somewhat.
Decreasing the water temperature
en
Startup after a water cutoff
Switch off the appliance (unscrew the fuse in the house
electrical installation).
Turn on the hot-water tap until the air is purged from
the pipe.
Switch the fuse back on again.
The appliance is ready for operation.
Saving energy
Set the desired warm water temperature directly on
the flow-through heater.
Mixing with cold water at the armature for water that is too
hot consumes unnecessarily water and energy.
At approx. 40 °C the unit operates most economically.
Cleaning
Simply wipe the appliance with a damp cloth.
Do not use intensive or abrasive cleaning agents.
Disposal
This appliance is labelled in accordance with Euro-
pean Directive 2002/96/EG concerning used elec-
trical and electronic appliances (waste electrical
and electronic equipment – WEEE).
The guideline determines the framework for the
return and recycling of used appliances as applica-
ble throughout the EU.
Please ask your specialist retailer about current
disposal facilities.
Guarantee
The guarantee conditions for this appliance are as defined by
our representative in the country in which it is sold.
Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of
sale or receipt must be produced when making any claim un-
der the terms of this guarantee.
11