Table of Contents
Advertisement
11
SERVICE WORK ON THE CHASSIS
11.18
Checking the chain, rear sprocket, engine sprocket, and chain guide
Main work
–
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning adjusting screws
Guideline
Chain tension
Turn adjusting screws
right chain adjusters
rear wheel is then correctly aligned.
Info
The upper chain section must be taut.
Chain wear is not always even. Repeat this measurement at different chain posi-
tions.
–
Tighten nuts
–
Make sure that the chain adjusters
–
Tighten nut
101989-10
Guideline
Nut, rear wheel spindle
Preparatory work
–
Raise the motorcycle with the rear wheel stand. (
.
.
on the left and right so that the markings on the left and
are in the same position relative to reference marks
.
.
on the left and right.
5 mm (0.2 in)
are installed correctly on adjusting screws
M25x1.5
p. 70)
82
. The
.
90 Nm
(66.4 lbf ft)
Advertisement
Table of Contents
