Page 1
By following the information contained in this guide, it will ensure both product and operator safety, together with longer life of the product itself. AlI photographs and drawings in this guide are supplied by Draper Tools to help illustrate the operation of the product.
Commercial copying, redistribution, hiring or lending is prohibited. No part of this publication may be stored in a retrieval system or transmitted in any other form or means without written permission from Draper Tools Limited. In all cases this copyright notice must remain intact.
CONTENTS 1. TITLE PAGE 1.1 INTRODUCTION......................2 1.2 REVISION HISTORY ....................2 1.3 UNDERSTANDING THIS GUIDE................. 2 1.4 COPYRIGHT NOTICE ....................2 2. CONTENTS 2.1 CONTENTS ........................3 3. GUARANTEE 3.1 GUARANTEE ....................... 4 4. GENERAL PRODUCT INFORMATION 4.1 GENERAL PRODUCT INFORMATION ............... 5 HEALTH AND SAFETY INFORMATION 5.1 GENERAL SAFETY INSTRUCTIONS FOR USE Personal safety......................
This guarantee applies in lieu of any other guarantee expressed or implied and variations of its terms are not authorised. Your Draper guarantee is not effective unless you can produce upon request a dated receipt or invoice to verify your proof of purchase within the guarantee period.
This product is designed to be used correctly and with care for the purpose for which it is intended. No liability is accepted by Draper Tools Limited for incorrect use or application of any of our products, and Draper Tools Limited cannot be held responsible for any damage to personnel, property or equipment when using this product.
Warning: Please read all safety warnings and all details carefully. Failure to follow the warnings may result in serious injury or major component damage. Important: Draper Tools recommends that this product should not be modified or used for any application other than that for which it was designed.
APPLICATION The 17609 has been developed as a crankshaft pulley holding tool for the vehicles listed below. Crankshaft holding tool for FORD, MAZDA and VOLVO engines. Used on the following Vehicles: Volvo C30 2006 - 2013 Volvo S40 2004 - 2012...
The following is for guidance only. Please refer to OEM derived data such as the vehicle manufacturer’s own data or Autodata. The use of this product is purely down to the user’s discretion and Draper Tools Limited cannot be held responsible for any damage caused what so ever.
PROCEDURE AND APPLICATION GUIDE Depending on manufacture and model, some engine components do change. Please check with Autodata or the manufacturer’s data before use. Note Please make sure that the holding tool is properly fitted into the aperture and locked in position, before any tension is applied. Instructions Fit into the crankshaft pulley aperture and rotate left or right to lock in place, depending on operation, whether you tightening or loosening the securing bolt.
Need help?
Do you have a question about the 17609 and is the answer not in the manual?
Questions and answers