Table of Contents
Advertisement
Crushed Glass Installation
Do not allow the crushed glass to block the air slots or to become too thick (maximum 1
layer deep on the burner). Failure to properly install glass may lead to sooting and
improper burning.
If converting to LP (propane), convert the appliance prior to placing the crushed glass.
Install the crushed glass on the glass tray following the directions below.
Quantity of Crushed Glass
Before installing the crushed glass, make sure the pilot guard is in place (it is zip-tied to the glass tray –
remove and discard the zip-tie). After installing the glass, remove the pilot guard. Make sure no glass
covers the pilot opening.
Pilot Guard
Disperse the crushed glass evenly along the glass tray.
Make sure the two air channels are free of crushed glass. Use the glass frame tool (or screwdriver) to
clear this area. Make sure the glass is only 1 layer deep on the burner.
© Travis Industries
Maintenance
No Logs (stock)
8 lbs. (3.5 Kg)
5/3/2021 - 1428
Driftwood Log Set
(NOTE: Install logs
first)
4 lbs. (1.8 Kg)
21
4415 HO ST (AUST)
Advertisement
Table of Contents
