Battery Replacement; Battery Box (Inside Fireplace); Transmitter Battery Installation; Power Outages - Lopi GreenSmart 4415 ST Aust Manual

14

Battery Replacement

Opening the Battery Box
There are (2) locking tabs in the upper corners of face of the battery box. Slide the tabs to the side and
the battery tray will pop outward enough to allow you to grab it. Pull the battery tray forward and remove
it from the battery box.
NOTE: When re-installing the battery tray, make sure to secure the battery tray into battery box using the
locking tabs to ensure a good electrical connection.

Battery Box (inside fireplace)

Install four AA batteries into the battery box (see below). These batteries act as a power backup in case
the household (AC) current goes out.
To access the battery box, remove the concealment cover and screen (see 18). Locate the heat shield
and remove it (see illustration below). NOTE: the heat shield must be in place whenever the fireplace is
in operation. The battery box may then be accessed.

Transmitter Battery Installation

Install the three included AAA batteries into the remote.

Power Outages

The remote will work if household current (AC power) is disconnected. The batteries inside the battery
box will continue to power the heater but the accent light and blower will not operate.
© Travis Industries
Operation
5/3/2021 - 1428 4415 HO ST (AUST)