Table of Contents
Advertisement
Once scanning begins, it continues until you press the
[Spacebar] to exit Auto Scan Mode. The port that was currently
active at the time scanning stopped remains active.
Note: While Auto Scan Mode is in effect, the console will not
function. You must exit Auto Scan Mode in order to regain
control of the console.
Last/Next Mode
This feature allows you to switch between computers in order to
monitor then manually. You can dwell on a particular port for as
long as you like – as opposed to Auto Scan Mode, which switches
after a fixed interval. To invoke Last/Next Mode, do the following:
1. Press and release [Alt+Ctrl+Shift].
2. Press and release 9.
3. Press [Enter].
Once Last/Next Mode is active, pressing the left Shift Key
[LShift] switches to the previous computer (from the currently
active one); pressing [RShift] switches to the next computer in the
installation.
Note: 1. There is another, shorter Hotkey combination to invoke
Last/Next Mode switching: Simply press the Left Ctrl
key twice in succession ([LCtrl] + [LCtrl]) to switch to
the previous computer; or press the Right Ctrl key twice
([RCtrl] + [RCtrl]) to switch to the next computer. This
method is available all the time – it does not have to be
invoked with [Alt+Ctrl+Shift].
2. While Last/Next Mode is in effect, none of the other
keyboard keys will function. You must exit Last/Next
Mode be pressing the [Spacebar] in order to use the
console for anything else.
- 16 -
Advertisement
Table of Contents
