Table of Contents
Advertisement
Setting the CS-82A's Scan Interval
The default amount of time that the CS-82A dwells on each port
is five seconds. You can change the scan interval at any time
while Auto Scan is in effect by keying in a number from 1 to 4 that
corresponds to the following scan intervals:
Once scanning begins, it continues until you press the
[Spacebar] to exit Auto Scan Mode. The port that has the KVM
focus at the time scanning stops remains active.
Note: While Auto Scan Mode is in effect, the console will not
function normally. You must exit Auto Scan Mode by
pressing the [Spacebar] in order to regain control of the
console.
Number
1
2
3
4
- 14 -
Scan Interval
3 seconds
5 seconds (default)
10 seconds
20 seconds
Advertisement
Table of Contents
