Set Up Rules And Alerts - Axis Q6075-E User Manual

AXIS Q60-E Series
Additional settings
1. Go to live view and select H.264.
2. Go to Settings > Stream.
3. Do one or more of the following:
Note
The zipstream settings are used for both H.264 and H.265.
- Turn on dynamic GOP and set a high GOP length value.
- Increase the compression.
- Turn on dynamic FPS.
Note
Web browsers do not support H.265 decoding. Use a video management system or application supporting H.265 decoding.
Set up network storage
To store recordings on the network, you need to set up your network storage.
1. Go to Settings > System > Storage.
2. Click Setup under Network storage.
3. Enter the IP address of the host server.
4. Enter the name of the shared location on the host server.
5. Move the switch if the share requires a login, and enter username and password.
6. Click Connect.
Record and watch video
To record video you must first set up network storage, see Set up network storage on page 13, or have an SD card installed.
Record video
1. Go to the live view.
2. To start a recording, click Record. Click again to stop the recording.
Watch video
1. Click Storage > Go to recordings.
2. Select your recording in the list and it will play automatically.

Set up rules and alerts

You can create rules to make your device perform an action when certain events occur. A rule consists of conditions and actions.
The conditions can be used to trigger the actions. For example, the device can start a recording or send an email when it detects
motion, or show an overlay text while the device is recording.
Trigger an action
1. Go to Settings > System > Events to set up a rule. The rule defines when the device will perform certain actions. Rules
can be setup as scheduled, recurring, or for example, triggered by motion detection.
13