Table of Contents
Advertisement
9
7.2
Wall mount mixer with S-connectors A7225AA
G1/2"
G3/4"
S-Connector style wall mount brackets
Pre-installation: Pipework should be run in or
behind the solid wall, terminating with G1/2"
female nipples securely fastened at 150 centres.
To achieve a seal, apply PTFE tape (suitable for water) to the G1/2" threads of the S-connectors.
Screw the S-Connectors into the nipples as shown, Use a spanner on the square flats if necessary.
As shown in the section 1, the S-connectors are offset, allowing connetion to nipples fitted at centres
between 137 to 163. Rotate the S-Connectors until 150 centres is achived.
Screw the escutcheons onto the
S-Connectors, hand tight is sufficient.
Ensuring seals are in place fit
the mixer to the connectors,
hand tighten the captive
nuts. Then use a 30
spanner (or strap wrench)
to make a good seal.
30
16
A7697AA
As with the bar shower mi-
xer, the wall mounted bath/
shower mixer is assembled
to the wall brackets in the
same way to complete the
installation.
30
Advertisement
Table of Contents
