Integra DRX-2.1 Basic Manual page 43

> Specifications > Advanced Setup
2� Speaker
You can make changes to the connection environment of the speakers and change the
volume level. Settings are automatically configured if you use AccuEQ Room Calibration.
This setting cannot be selected if headphones are connected or audio is output from the
speakers of the TV.
■ 1� Configuration
Setting Item Default Value
Speaker 7.1 ch
Channels
Subwoofer Yes
Height Speaker Top Middle
Zone Speaker No
> Listening Modes
Setting Details
Select "2.1 ch", "3.1 ch", "4.1 ch", "5.1 ch", "6.1
ch", "7.1 ch", "2.1.2 ch", "3.1.2 ch", "4.1.2 ch", or
"5.1.2 ch" to suit the number of speaker channels
connected.
Set whether a subwoofer is connected or not.
"Yes": When subwoofer is connected
"No": When subwoofer is not connected
Set the speaker type if height speakers are
connected to the SURROUND BACK or HEIGHT
terminals.
Select "Front High", "Top Front", "Top Middle", "Top
Rear", "Rear High", "Dolby Speaker (Front)", or
"Dolby Speaker (Surr)" according to the type and
layout of the connected speakers.
• If an item cannot be selected even though
connection is correct, check that the settings
in "Speaker Channels" matches the number of
connected channels.
Set the connection of speakers to Zone 2 speaker
terminals.
"Zone 2": When speakers are connected to Zone 2
speaker terminals
"No": When speakers are not connected to Zone 2
speaker terminals
> Network Functions
Setting Item Default Value Setting Details
Bi-Amp No Set whether the front speakers are bi-amp
connected.
"No": When front speakers are not bi-amp
connected
"Yes": When front speakers are bi-amp connected
Speaker 6ohms Set the impedance (Ω) of the connected speakers.
Impedance "4ohms": When any of the connected speakers
have 4 Ω or more to less than 6 Ω impedance
"6ohms": When the connected speakers all have
6 Ω or more impedance.
> Basic Manual
Troubleshooting Supplementary Information, etc� |
• This item will be fixed to "No" when the "Zone
Speaker" setting is "Zone 2".
• This setting cannot be selected when surround
back speakers or height speakers are installed.
• For impedance, check the indications on the
back of the speakers or their instruction manual.
11