Renkforce 2203406 Operating Instructions Manual page 65

Setting function "KEY BEEP SETTING"
After starting setting mode (keep the "SET" (5) button pushed for 2 seconds), the setting function "TIME SETTING"
will appear.
Then push the " " (3) briefly repeatedly until the setting function "KEY BEEP SETTING" is displayed.
Then briefly push the button "
Use the " " (1) or "
button or not.
Setting function "REREGISTER TRANSMITTER"
You can register the outdoor sensor with the base station again here.
After starting setting mode (keep the "SET" (5) button pushed for 2 seconds), the setting function "TIME SETTING"
will appear.
" (3) briefly repeatedly until the setting function "REREGISTER TRANSMITTER" is displayed.
Then push the "
Then briefly push the button "
Use the " " (1) or "
button.
All display areas of the outdoor sensor will now no longer display any data, but only dashes. The base station will now
scan for the outdoor sensor.
When the base station has found the signal of the outdoor sensor, measured values of the outdoor sensor will be
displayed on the base station again.
If necessary, push the "RESET" (33) button on the bottom of the solar module to reset the outdoor sensor.
You may also need to remove the special rechargeable batteries from the outdoor sensor before starting
the setting function "REREGISTER TRANSMITTER" and cover the solar module for 1 minute. Insert the
alkaline batteries again after starting the setting function "REREGISTER TRANSMITTER".
" (4).
" (2) buttons to select whether a brief confirmation sound is to be output at every push of a
" (4).
" (2) to select the "ON" setting and leave the setting menu by briefly pushing the "HISTORY"
65