Sensor Installation; A) Install U-Bolts And Metal Plate; B) Install Wind Speed Cups - Renkforce 2203406 Operating Instructions Manual

8. Sensor installation

a) Install U-bolts and metal plate

The wind vane and speed cups are fragile. To help prevent damage, install the U-bolts and metal plate first.
• The U-bolts are used to mount the sensor package onto a pole.
• Once the metal plate is inserted, insert both U-bolts through the respective holes of the metal plate as shown.
Loosely screw on the nuts on the ends of the U-bolts. You will tighten these later during final mounting. Final
assembly is also shown.

b) Install wind speed cups

• Left image: Push the wind speed cup assembly onto the shaft on the top side of the sensor package.
• Right image: Tighten the set screw using a cross head screwdriver (size PH0).
Make sure the cup assembly can rotate freely. There should be no noticeable friction when it is turning.
51