Renkforce 2203406 Operating Instructions Manual page 63

• Subfunction "ENTER TIME": Manual setting of time and date
In case of receiver problems for the DCF signal, the time and date can be set manually.
Change the respective flashing value with the "
tive button pushed).
" (4) button to switch between the settings for hours, minutes, day, month and year.
Briefly push the "
• Subfunction "TIME ZONE": Setting the time zone
" (1) or "
Use the "
• Subfunction "RCC RECEIVE": Switching DCF reception on/off
" (1) or "
Use the "
• Subfunction "DAYLIGHT SAVING TIME": Automatic daylight saving time adjustment
This setting function appears only if DCF reception has been switched off in the previous setting function ("OFF").
" (1) or "
In this case, the "
("ON") or off ("OFF").
• Subfunction "NORTH/SOUTH": Setting for northern/southern hemisphere for moon phase display
Here, you can set if the base station is located in the northern or the southern hemisphere of the earth to display
the moon phase correctly.
" (1) or "
Use the "
(southern hemisphere).
Setting function "UNIT SETTING"
After starting setting mode (keep the "SET" (5) button pushed for 2 seconds), the setting function "TIME SETTING"
will appear.
" (3) briefly repeatedly until the setting function "UNIT SETTING" is displayed.
Then push the "
Use the " " (4) button to select the desired subfunction:
• Subfunction "LIGHT UNIT": Unit of lighting strength
Use the " " (1) or "
• Subfunction "TEMPERATURE UNIT": Unit of the temperature
Use the " " (1) or "
• Subfunction "BAROMETRIC UNIT": Unit of the barometric pressure
Use the " " (1) or "
inHg).
• Subfunction "WIND SPEED UNIT": Unit of the wind speed
Use the " " (1) or "
mph)
• Subfunction "RAINFALL UNIT": Unit of the rain volume
" (1) or "
Use the "
" (2) buttons to select the time zone in the range of +12...-12 hours.
" (2) buttons to switch DCF reception on ("ON") or off ("OFF").
" (2) buttons can be used to switch automatic daylight savings time adjustment on
" (2) buttons to choose between "NORTH" (northern hemisphere of the earth) and "SOUTH"
" (2) buttons to select the desired unit for the lighting strength (you can set W/m², lux, fc).
" (2) buttons to select the desired unit for the temperature (you can set °C, °F).
" (2) buttons to select the desired unit for the barometric pressure (you can set hPa, mmHg,
" (2) button to select the desired unit for the wind speed (you can set km/h, bft, m/s, knots,
" (2) buttons to select the desired unit for the rain volume (you can set mm, inch).
" (1) or " " (2) buttons (for quick adjustment, keep the respec-
63