Table of Contents
Advertisement
P/N 0535974_R
Fascia Panel Alignment
Applies to (IC2 / IC2X / IC3)
Fascia panel can slide toward the center of
case lineups to eliminate gaps .
Fascia trim is then needed at the end of either
side of the lineups to eliminate gaps at the ends .
1 . Loosen the fascia screws located at the
inner bottom of fascia .
2 . Slide fascias toward the lineup center to
eliminate gaps between fascias and tighten the
screws .
CASE 1
3 . Place optional fascia trim between fascia
joints between end panel and fascia and
between case lineup joints . Install tape to joint
first, then attach bottom and top fascia trim .
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Screw
Center
CASE 2
Medium Temperature
3-9
CASE 3
Merchandisers
Advertisement
Table of Contents
