Table of Contents
Advertisement
P/N 0535974_R
APPLY GASKETS
(DOOR CASES)
Case bolting details begin on the next page .
Refer to Page 1-6 for hardware list .
Do not pull cases together with bolts .
Cases must be moved together as close
as possible . Follow sequence balloons
to tighten bolts .
LEGEND:
A = 1/2 x 1/2 INCH GASKET
B = NEUTRAL CURING SILICONE SEALANT
C = PIN-ALIGNMENT
F = PLATE BOTTOM DOOR RAIL ALIGNMENT
IMPORTANT:
Do not pull cases together with bolts. Cases must be moved
together as close as possible Follow sequence balloons to
tighten bolts.
Merchandiser case joint & end gasket to be applied on only one
side of joint.
Merchandiser partition gasket to be applied on both sides of
joint.
Remove end shipping braces as described on Page 1-4
Cases must be leveled as described on Page 1-5
Removed any casters - if installed
Install case lineup from left to right
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
5/16 X 4 1/2 BOLT
& ALIGNMENT CONE
5/16 X 4 1/2 BOLT
7
5/16 X 4 1/2 BOLT
6
1/4 X 3/4 CAP SCREW
11
A
1/4 X 3/4 CAP SCREW
10
F
C
5/16 X 3/4 BOLT
5
A
5/16 X 7 BOLT
& ALIGNMENT CONE
Remove shelves, display racks, pans & interior back panels at
the joining area
Insert gasket into case channels the entire length with no gaps
Do not stretch gasket, especially around corners
Do not butt gaskets, always overlap them
Remove paper backing after gasket has been applied
Perimeter gasket is required by NSF
Apply a continuous bead of neutral curing silicone sealant
Joints must be air tight to prevent formation of ice or condensation.
Mi n i m um 1 1/2in space
between case & wall
5/16 X 2 3/4 BOLT
5/16 X 2 3/4 BOLT
8
4
B
5/16 X 4 1/2 BOLT
& ALIGNMENT CONE
5/16 X 4 1/2 BOLT
& ALIGNMENT CONE
A
Smooth
B
Surface
3
A
Medium Temperature
1-25
9
A
2
1
Smooth
Surface
Merchandisers
Advertisement
Table of Contents
