Table of Contents
Advertisement
P/N 3032067_E
UL LISTING
These merchandisers are manufactured to
meet ANSI/ UL 471 standard requirements for
safety . Proper installation is required to main-
tain the listing .
FEDERAL / STATE REGULATION
These merchandisers at the time they are man-
ufactured, meet all federal and state/ provincial
regulations . Proper installation is required to
ensure these standards are maintained . Near
the serial plate, each merchandiser carries a
label identifying the environment for which the
merchandiser was designed for use . A Type II
fan speed control kit is required for each mer-
chandiser to operate at Type II conditions .
ANSI/NSF-7 Type I – Display Refrigerator / Freezer
Intended for 75°F (24°C) / 55%RH Ambient Application
ANSI/NSF-7 Type II – Display Refrigerator / Freezer
Intended for 80°F / 55%RH Ambient Application
ANSI/NSF-7 – Display Refrigerator
Intended for Bulk Produce
LOCATION
These merchandisers are designed for displaying
products in air conditioned stores where
temperature is maintained at or below the
ANSI/ NSF-7 specified level and relative
humidity is maintained at or below 55% .
Placing refrigerated merchandisers in direct
sunlight, near hot tables or near other heat
sources could impair their efficiency . Like
other merchandisers, these are sensitive to air
disturbances . Air currents passing around
merchandisers will seriously impair their
operation . Do NOT allow air conditioning,
electric fans, open doors or windows, etc . to
create air currents around the merchandisers .
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
INSTALLATION
PRODUCT TEMPERATURE
Product should always be maintained at proper
temperature . This means that from the time the
product is received, through storage, preparation
and display, the temperature of the product
must be controlled to maximize product life .
Merchandiser must operate for 24 hours
Regularly check merchandiser temperatures.
Do not break the cold chain. Keep products in
cooler or freezer before loading into merchandiser.
Medium temperature merchandisers are designed
Low temperature merchandisers are designed
A 1 .5 inch (38 mm) space between the rear
of the merchandiser and wall must be main-
tained for air circulation . However, in high
ambient conditions, sweating may still occur .
If this happens install a method of forced
ventilation such as a fan ventilation kit .
»
before loading product!
ANSI Z535.6-2011 (R2017)
for loading ONLY pre-chilled products.
Page 18
Providing Information About Safety Messages in Collater
for loading ONLY frozen products.
A1
Explanation of Signal Words and Symbols
Signal words and safety symbols that are used in a product's collateral ma
be defined in collateral materials if space is available.
A1.1
Safety Alert Symbol
The meaning of the safety alert symbol may be provided in collateral mate
be used for this purpose.
A1.2
Signal Words
The meaning of the different signal words as defined by the ANSI Z535.6 a
may be explained in collateral materials. The following artwork may be use
Use caution when working around refrigeration
lines or water lines. Damage to equipment and/
or personal injury could occur.
Low Temperature
A1.3
Other Highlighting Conventions
The meaning of any other highlighting conventions used to differentiate sa
1-1
Annex A
Safety Signs and Labels
(Informative)
This is the safety alert symbol. It
to potential physical injury hazar
messages that follow this symbo
injury or death.
DANGER indicates a hazardou
avoided, will result in death
WARNING indicates a hazardo
avoided, could result in dea
CAUTION indicates a hazardou
avoided, could result in min
NOTICE is used to address pra
physical injury.
Safety instructions (or equivale
safety-related instructions o
Merchandisers
Advertisement
Table of Contents
