Installing End Splashguards - Hussmann Insight Installation & Operation Manual

P/N 3032067_E
INSTALLING END SPLASHGUARD
1 . End splashguard must be slid in from the
front, so that it fits behind the end panel .
Attach end splashguard brackets (2) to base at
locations shown in the illustrations below .
2 . Align forward edge of splashguard end
panel to the inside of front splashguard .
Fasten end splashguard to bracket with
screws .
End Splashguard Panel fits to the
inside of End Assembly.
Loosen End Assembly bolt
Bracket End
Splashguard
Splashguard Front
(Quantity 1)
(End Assembly)
Align back edge
of Splashguard with
back edge of end
assembly
Bolt 5/16 inch - 18
(Quantity 1)
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
slide Splashguard from
front to back between
end and case
Button Plug
Hex Nut
5/16 inch - 18
(Quantity 1)
#8 Screw x
TR HD
(Quantity 2)
Splashguard
- End
Place Splashguard - End to the
inside of Splashguard - Front
Flat Washer
Splashguard - End
(Quantity 1)
Splashguard Front
Install end splashguard before
installing front splashguards.
Splashguard Front
Low Temperature
Merchandisers
3-3