Table of Contents
Advertisement
5-4
6 . Clean all surfaces including shelves and
honeycomb by spraying down water (prefera-
bly warm) and mild detergent . Use a brush or
cleaner pad if necessary to aid in penetrating
dirt .
7 . Remove all the shelves and set aside then
remove the back panels .
8 . Clean the backside of the back panels in the
case as you remove them .
9 . Clean the newly exposed surfaces and the
coil by spraying down with water (preferably
warm) and a mild detergent solution .
ANSI Z535.6-2011 (R2017)
Page 18
10 . Rinse the newly exposed surfaces and the
Providing Information About Safety Messages in Collateral Materials and Product
coil with water then spray with a sanitizer .
Allow surfaces to air-dry, since wiping would
defeat the purpose of sanitizing .
A1
Explanation of Signal Words and Symbols
11 . Replace the back panels and shelves .
Signal words and safety symbols that are used in a product's collateral materials or on the product may
be defined in collateral materials if space is available.
12 . Rinse all surfaces with water, then spray
A1.1
Safety Alert Symbol
with a sanitizer . Allow surfaces to air-dry since
The meaning of the safety alert symbol may be provided in collateral materials. The following artwork may
wiping would defeat the purpose of sanitizing .
be used for this purpose.
13 . Replace all remaining internal parts care-
fully so that they seat properly . This is neces-
sary for proper case operation .
14 . Turn ON power to the fans .
A1.2
Signal Words
The meaning of the different signal words as defined by the ANSI Z535.6 and ANSI Z535.4 standards
15 . Replace product .
may be explained in collateral materials. The following artwork may be used for this purpose.
»
Do not use mechanical devices or other means
to accelerate the defrosting process.
»
Do not use electrical appliances inside the food
storage compartments of the case(s).
P/N 3032067_E
A1.3
Other Highlighting Conventions
The meaning of any other highlighting conventions used to differentiate safety messages (e.g., text
Annex A
Safety Signs and Labels
(Informative)
This is the safety alert symbol. It is used to alert you
to potential physical injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
DANGER indicates a hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION indicates a hazardous situation which, if not
avoided, could result in minor or moderate injury.
NOTICE is used to address practices not related to
physical injury.
Safety instructions (or equivalent) signs indicate specific
safety-related instructions or procedures.
U.S. & Canada 1-800-922-1919 • Mexico 01-800-890-2900 • www.hussmann.com
CLEANING HONEYCOMB ASSEMBLIES
Honeycombs should be cleaned every six
months, or depending on store environment
the honeycombs may need to be cleaned more
often . Dirty honeycombs will cause cases to
perform poorly .
The honeycombs may be cleaned with a
vacuum cleaner . Soap and water may be used if
all water is removed from the honeycomb cells
before replacing . Be careful not to damage the
honeycombs .
Deflector
Clip releases
Honeycomb
1 . Remove honeycomb by pulling clip as
shown above .
2 . Clean and dry the honeycomb .
3 . Honeycomb is not symmetrical . Orient slot
at the top and different color straw to the back .
3 . After cleaning, replace honeycomb . Ensure
clip is centered and engaged along full-length
of honeycomb .
Damaged honeycomb must be replaced.
Slit at top
Honeycomb
Advertisement
Table of Contents
